Go to content
2. Task description – Nordsyn project
part 1
Project I: Modification and improvements of test standard, EN16510
Technical assessment of existing relevant test parameters, measurements methods and test conditions.
Suggestions for modified and improved version of EN16510 test standard
Assessment of practical feasibility and cost estimation for manufacturers
Estimation (cautious) of the potentially achieved tolerance percentage.
The full project description is attached as
annex 1
.
Nordsyn ecodesign – task 1 report
About this publication
PDF
1. Background
2. Task description – Nordsyn project part 1
3. Test philosophies compensating for lack of reproducibility
Technical assessment of existing relevant test parameters and conditions (a) – including suggestions for modified and improved test proceedings (b)
3.1 Start and end definitions of the cycle
3.2 Determination of flue gas temperature
3.3 Order and number of burn cycles
3.4 Reset minimum cycle duration to 45 minutes
3.5 Avoid any intermediate pauses between combustion cycles
3.6 Part load heat output testing
3.7 Standardize the test fuel
4. Assessment of practical feasibility and added costs for manufacturers
5. Estimation of the achievable tolerance improvement by adopting these recommendations
6. Summary
Annexes